Cromar Clear Woodworm & Dry Rot Killer
Description: Cromar Woodworm + Dry Rot Killer can be used both to protect construction timbers against attack by woodworm and to give fungal protection. Typical uses are on doors and window frames, floorboards, joist roof timber and sheds etc. It is a clear solution and therefore can be overpainted or varnished when dry. It can also be used to treat dry rot fungal growth on brickwork and masonry.
Preparation: Ensure that the timber to be treated is fully dry and that paint or varnish will not restrict penetration. Replace rotted timber, cutting back to sound areas. Cure sources of dampness and treat dry rot (and surrounding areas) on brickwork and masonry with two coats of Cromar Woodworm + Dry Rot Killer.
N.B: Be sure to read all conditions relating to use and safety listed on the container before commencing work.
Application: Before start, ensure that the cap is firm and shake container vigorously to thoroughly mix contents. Apply to the prepared surface two liberal coats of Cromar Wood Preserver (chosen colour or type) by brush or low-pressure spray, ensuring saturation of joints and end grain. Alternatively dip for 10-15 minutes. If timber is to be used below ground level, the dipping time should be increased to one hour or three brush coats should be used. Sufficient time should be allowed between coats to permit penetration of the preserver, before applying next coat.
N.B: Please note that the final colour, when dry, will depend of the type of wood to which it is applied and whether any previous application of coloured preservative or Creotreat has been made. In such instances, we recommend a test area to ensure that the finished result is acceptable.
Coverage Rates: This is greatly dependent on the type of timber being treated, but as a rough guide coverage will be 6 to 8m² per litre for each coat.
Cleaning: Brushes etc. can be cleaned with White Spirit followed by detergent.
Storage Conditions: Containers should be stored out of direct sunlight in dry conditions away from sources of ignition. They should be stored undercover below a temperature of 35°C.
There are no reviews yet.
Deliveries can be made throughout most of Lancashire, approximately 20 miles radius from our depot at Accrington, Lancashire.
Other locations may also be arranged for direct loads from our suppliers e.g. full loads of bricks or blocks.
We operate 3 crane offload vehicles:
Pricing will vary depending on the goods required and distance travelled.
We can offer very competitive rates for delivery — please contact us for more details.