Greengates Builders Merchants

European Plastics Continuous Dry Verge System

Continuous Dry Verge System Available From Greengates Builders Merchants Accrington, Lancashire.


European Plastics Ltd home of the Dry Verge System giving complete protection to your property against water penetration for the joints between tiles and brickwork or bargeboard at gable ends.

 Easily fitted
 No undercloak required
 No mortar joint required
 No special tools or adhesives
 Saves on time and labour
 Can be fitted in all weather

Provides an attractive line and finish to the gable end and requires no maintenance.

Provides that added finish when used with uPVC facias and soffits.

Available in Black in 5 metre lengths with connector units available for longer runs.


Fitting Instructions. Continuous Dry Verge is designed to fit on the gable end of houses, between the underside of the battens and outer wall or roof ladder.

Ensure the gable wall is reasonably level and free from projections. The roofing felt and battens should be laid across the cavity and the battens finish flush with the outer wall or outer edge of the bargeboard.Take a length of verge extrusion and plumb cut the upper end.Cut the verge extrusion approximately 6 inches longer than the rafter. Remember to allow 10 mm between left & right verge at the ridge for expansion and fitting the ridge cap.

At the eaves end of the verge, cut a line the length of one tile between the horizontal flange and the fin. This allows the verge extrusion to fit over the tiling fillet or felt support tray at the eaves end.The bottom flange of the verge extrusion is then pushed between the wall / roof ladder and the batten. Fix through both batten and verge into the wall .


Alternatively the verge can be cut and angled approximately 250 mm from the eaves end or near the first batten at the eaves, leave 5 mm for expansion. Fit the smaller offcut of verge with the flange under the batten ensuring that the length extends approximately 50 mm past the line of the fascia into the gutter. Use the angled connector which should be fixed, using silicone, over the angled cuts for a neat finish.

The tiles are then laid in the usual manner ensuring that the verge tiles are inserted fully into the verge extrusion where the top flange will hold them firmly.

At the eaves end the verge should be cut square, flush to the lower tile. The lower fin of the verge may require slight trimming to avoid it interfering with the gutter.

A small notch may be required in the wall side of the gutter to accommodate the verge channel ensuring that the water drains effectively into the gutter.



So if you want more information on the Dry Verge System come in and see us or give us a ring today

Greengates Builders Merchants delivering to the whole of Lancashire including: Accrington, Blackburn, Burnley, Clitheroe, Darwen, Great Harwood, Haslingden, Padiham and Pendle.













Posted in Product news on