Get Rid Of Mould For Good!
WYKAMOL MOULD ERADICATION KIT NOW AVAILABLE FROM GREENGATES BUILDERS MERCHANTS ACCRINGTON, LANCASHIRE.
All the products described below can be used independently of each other but in most cases we recommend the full 3-stage treatment is used to achieve the best possible control over mould re-growth or colonisation.
The Wykamol Mould Control System (MCS)is a three-stage treatment for walls, ceilings etc. affected by condensation mould. When Wykamol recommendations are followed, and all three stages are completed, surfaces will exhibit excellent resistance to mould growth even under severe condensation conditions. Typically, full control can be achieved for up to 5 years but this can be extended considerably where moisture control measures are implemented.
STAGE 1 - STERILISATION
MouldClear Concentrate – MCS1
Based on established active ingredients, the MouldClear solution both cleans and sterilises the surface as the first stage towards re-decoration. Alternatively, it can be used singly, as required, to control spore development where other measures are to be completed at a later time.
Supplied as a 5X concentrate, this product is designed to provide an initial wash/ sterilisation treatment to remove and kill mould spores and surface growths on painted or papered surfaces. Wykamol recommend the wash is applied before removing mould-damaged paint or paper (to minimize spread of viable spores).
When applied liberally to papered surfaces it can be an effective stripping agent. After the first wash, and once damaged paper or plaster has been removed, it is necessary to apply a second wash with MouldClear solution to leave the surface clean and remove any residues of dead spores etc. It is recommended that mould affected woodchip and Anaglypta papers are always removed and are not recommended for re-instatement.
STAGE 2 - SURFACE PREPARATION
Biobond Stabiliser – MCS2
Biobond Stabiliser is a ready-for-use biocidal primer for ‘bonding’ plaster etc. surfaces prior to re-decoration. It contains a deeply penetrating inorganic biocide designed to kill off the ‘roots’ (hyphae) of the mould thereby preventing re-growth underneath freshly applied paint or paper finishes. The solution should be applied to reasonably dry surfaces to facilitate penetration of the substrate.
STAGE 3 – DECORATION
Anti-Mould Emulsion – MCS3
Wykamol Anti-mould Emulsion is a high quality decorative paint for internal surfaces and contains a long lasting biocide for the control of surface moulds. Available in Silk and Matt finishes and in Brilliant White, Magnolia and a range of pastel colours, the formulation has been proven over many years to provide effective resistance to mould growth in difficult areas. It is recommended that the Silk finish is used in Kitchens and Bathrooms.
This Wykamol product is a full multipurpose kit providing everything you need to deal with mould problems. Comes supplied with cleaning agents, all equipment and paint additives to treat and clean mould issues in domestic properties.
For further information about this and all the other Wykamol products we stock just give us a ring or come in and see us.